|
Effortless, No-Drill Hanging Solution for Lightweight Panels
For standing a panel on a desk or table top
For panels made from aluminium, acrylic, di-bond, glass, steel and similar.
The Panel Stand simply clips into the steel self-adhesive base plate stuck onto the back of the panel. The stand is easily bent to fine adjust the standing angle.
Measurements
Panel Stand: 75mm long with a clear bumper
Base Plate: 80mm wide x 40mm high
A set consists of 1 stand and 1 base plate.
✅ Strong Adhesive Backing – High-quality polyethylene foam pad with aggressive pressure-sensitive adhesive.
✅ Easy to Install – Simply peel and stick onto a clean, degreased surface.
✅ Versatile Mounting – Works with hooks, nails, and screws for flexible hanging options.
✅ Designed for Lightweight Substrates – Compatible with Chromaluxe, Dibond, Fomex, and acrylic.
✅ Flush Hanging Design – Includes bumpers to keep panels level against the wall.
📌 Important Usage Information:
- Adhesive peel strength: Rated to 25 N/25 cm (performance may vary based on environment & application).
-
Not recommended for valuable artwork due to adhesive limitations.
-
Do not thread wire/cord between two plates – this may cause them to detach.
-
One larger plate is more effective than two smaller plates.
-
Preparation is Key – Clean the panel with Isopropyl Alcohol Wipes/Spray before applying.
-
Allow 24 hours for adhesive curing before hanging for best results.
A fast, simple, and cost-effective way to hang your lightweight prints and panels securely!
|
